Using The Ir Remote Commander - Sony PXW-X200 Operating Instructions Manual

Turning the EVF on/off
With the factory setting, the EVF is turned on
when the LCD monitor is in its park position or is
rotated to face the subject.
You can change the setting so that the EVF is
always on regardless of the status in the LCD
monitor, using "EVF" (page 96) of the LCD/VF
SET menu. Change the "Power" setting from
"Auto" to "On."
Adjusting the focus in the EVF
The eyepiece focusing (diopter compensation)
knob (page 8) enables adjustment to match the
eyesight of the operator, who can then view the
image clearly through the eyepiece.
Adjusting the backlight
The brightness of the backlight for the EVF can
be switched between High and Low.
Set "Backlight" in "EVF" (page 96) of the LCD/
VF SET menu.
Switching between color and
monochrome modes
For the EVF screen, color or monochrome display
can be selected.
Set "Mode" in "EVF" (page 96) of the LCD/VF
SET menu.
Select "B&W" if checking the subject and
focusing are easier on the monochrome display.
If you assign "EVF Mode" to one of the
assignable buttons (page 37), you can switch
between color and monochrome by pressing the
button.
Adjusting the contrast and brightness
Use "EVF" (page 96) of the LCD/VF SET menu
to make adjustments. Adjusting the brightness
and other items has no effect on pictures being
recorded.
Using the IR Remote
Commander
Before use
Before you use the supplied IR Remote
Commander for the first time, pull out the
insulation sheet from the battery holder.
Insulation sheet
A CR2025 lithium battery is set in the holder at
the factory.

Using the IR Remote Commander

For controlling the camcorder from the IR
Remote Commander, activate the remote control
function of the camcorder after turning the power
on.
Activating/deactivating the remote control
function can be achieved using the Setup menu.
To activate using the menu
Press the MENU button to set the camcorder to
Menu mode, then set "IR Remote" (page 104) of
the System menu to "On."
To activate using the assignable button
If you assign "IR Remote" to one of the
assignable buttons (page 37), you can switch
between activating and deactivating the remote
control function by pressing the button.
Notes
• Aim the IR Remote Commander towards the remote
sensor to operate your camcorder.
• Point the remote sensor away from strong light sources
such as direct sunlight or overhead lighting. Otherwise,
the IR Remote Commander may not function properly.
• When you are operating with the IR Remote
Commander supplied with your camcorder, your video
device may also operate. In that case, select a
commander mode other than DVD2 for your video
device, or cover the sensor of your video device with
black paper.
• The remote control function is deactivated
automatically when the camcorder is turned off to
prevent a malfunction. To use the remote control
function, activate it when the camcorder is turned on.
Using the IR Remote Commander 19