Using Ac Power (Dc In Power); Turning The Power On/Off - Sony PXW-X200 Operating Instructions Manual

If the battery charge remaining becomes
low
If the battery charge remaining decreases to a
certain level during operation (Low BATT
status), a low-battery message, flashing of the
tally lamps, and a beep sound will warn you.
If the remaining further decreases to a level at
which operation cannot be continued (BATT
Empty status), a battery-empty message appears.
Replace the battery pack with one that is fully
charged.
To change the message levels
The Low BATT level is set to 10% of full charge,
and the BATT Empty level is set to 3% of full
charge at the factory. These settings can be
changed with "Battery Alarm" (page 104) of the
OTHERS menu.

Using AC Power (DC IN Power)

Connection example: when connecting BC-U1
1
3
1
Connect the DC power output cable of
the BC-U1 to the DC IN connector of
the camcorder.
2
Connect the power cord of the BC-U1 to
an AC power source.
3
Set the mode switch of the BC-U1 to the
DC OUT position.

Turning the Power On/Off

To turn the power on, set the power switch (page
7) to the ON position (the ? position). To turn the
power off, set the power switch to the OFF
position (the 1 position).
Notes
• This camcorder uses a little standby power even when
• When removing the battery pack or the DC IN power,
2
BC-U1
the power switch is set to OFF. Remove the battery
pack if the camcorder will not be used for a prolonged
period.
be sure to first set the power switch to the OFF
position. Removing the battery pack or the DC IN
power while the camcorder is on may cause damage to
the camcorder or the SxS memory card.
Power Supply 17