Sony PXW-X200 Operating Instructions Manual page 92

AUDIO SET
Menu items Subitems and setting values Contents
CH1&2 AGC Mode
CH3&4 AGC Mode
1KHz Tone
Wind Filter CH-1
Wind Filter CH-2
Wind Filter CH-3
Wind Filter CH-4
EXT CH Select
Audio Output Monitor CH
Setting for audio
outputs
Output CH
Alarm Level
Beep
92 Setup Menu List
Mono / Stereo
Mono / Stereo / Off
On / Off
On / Off
On / Off
On / Off
On / Off
CH-1
CH-1/CH-2
CH-1/CH-2 (CH-3/CH-4)
CH-1+CH-2 (CH-3+CH-4)
CH-1 (CH-3)
CH-2 (CH-4)
CH-1/CH-2
CH-3/CH-4
0 to 7 (4)
On / Off
Select auto tuning for the input level of an analog audio signal
recorded to CH-1/CH-2.
Mono: Perform for each channel.
Stereo: Perform in stereo mode.
Select auto tuning for the input level of an analog audio signal
recorded to CH-3 or CH-4.
Mono: Perform for each channel.
Stereo: Perform in stereo mode.
Off: Do not perform auto tuning. The Limiter Mode setting is
applied.
Turn the 1-kHz reference tone signal on/off.
Turn the wind filter for CH1 on/off.
Turn the wind filter for CH2 on/off.
Turn the wind filter for CH3 on/off.
Turn the wind filter for CH4 on/off.
CH-1: To record the CH1 external input signal to both CH-1
and CH2 (when the CH-2 AUDIO IN switch is set to
EXT). If "CH4 Input Source" is set to "External," you can
also record to CH4.
CH-1/CH-2: To record each external input signal to its
respective channel.
Select the audio channel(s) to be fed to the headphones and
the built-in speaker.
CH-1/CH-2 (CH-3/CH-4): Stereo
CH-1+CH-2 (CH-3+CH-4): Mix
CH-1 (CH-3): CH-1 (CH-3) only
CH-2 (CH-4): CH-2 (CH-4) only
( ): with Output CH set to "CH-3/CH-4"
Select audio output channels from either channels 1 and 2 or
channels 3 and 4.
Set the alarm sound volume.
Select whether or not to sound a beep upon each operation.