Standalone Operation; Removing The Rear Cover; Using Ac Power (Via The Dc In Connector); Using Ac Power (With Ac Adaptor) - Sony HXC-D70 User Manual

Standalone Operation

When the camera is used on its own without connecting a
CCU, use a battery pack or AC power to operate it. Be sure to
remove the rear cover before using a battery pack or AC
power.
For safety, use only a Sony battery pack or AC adaptor listed
below.
• BP-GL95A/GL65A/L60S/L80S Lithium-ion Battery Pack
• AC power using the AC-DN2B/DN10 AC Adaptor
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended
by the manufacturer.
When you dispose of the battery, you must obey the law in the
relative area or country.
ATTENTION
Il y a danger d'explosion s'il y a remplacement incorrect de la
batterie.
Remplacer uniquement avec une batterie du même type ou
d'un type équivalent recommandé par le constructeur.
Lorsque vous mettez la batterie au rebut, vous devez
respecter la législation en vigueur dans le pays ou la région où
vous vous trouvez.
VORSICHT
Explosionsgefahr bei Verwendung falscher Batterien.
Batterien nur durch den vom Hersteller empfohlenen oder
einen gleichwertigen Typ ersetzen.
Wenn Sie die Batterie entsorgen, müssen Sie die Gesetze der
jeweiligen Region und des jeweiligen Landes befolgen.

Removing the Rear Cover

Remove the rear cover before using AC power or attaching a
battery pack to operate the camera on its own.
To remove the rear cover
1 Holding the release button on the camera in, 2 pull the rear
cover up.
22
Standalone Operation
To attach the rear cover
You can attach the rear cover by following the detaching
procedure in reverse order. Be sure to engage the guide on
the backside of the rear cover with the battery mount on the
camera.
Using AC Power (via the DC IN
connector)
Connect an optional DC power cord to the DC IN connector on
the camera, and then connect the cord to the DC output
connector of the AC-DN10/DN2B AC adaptor or BC-L70/L160
battery charger.

Using AC Power (with AC adaptor)

Mount an AC-DN2B/DN10 on the camera, then connect to the
AC power supply.
The AC-DN2B/DN10 can supply up to 100 W of power.
Rear cover