Interpreting Switch Leds; System Leds; Port Leds; Post-Operation Leds - Fujitsu Brocade 6545 Gen5 Hardware Reference Manual

For descriptions of LED states, refer to the following sections:
•
•

Interpreting switch LEDs

After the Brocade 6545 16 Gbps FC Switch Module is inserted in the BX400 or BX900 S2 Blade
Server, the switch LEDs become active. The LEDs indicate switch status and system status. LED
behavior is indicated by color and speed pulsations, and is identified in greater detail in the
following sections:
•
•
•
•

System LEDs

Figure 7
Refer to
TABLE 5
Callout
1
2
3

Port LEDs

Each external port on the Brocade 6545 16 Gbps FC Switch Module is equipped with a bi-colored
(green and amber) LED that identify port behavior.
Figure 7
Table 7

POST-operation LEDs

The system status LEDs flash in various patterns during bootup, POST, or other diagnostic tests.
This is normal and does not indicate a problem unless the LEDs do not indicate a healthy state
after the boot processes and diagnostic tests are complete.
Brocade 6545 Gen5 16-Gbps FC Switch Module Hardware Reference Manual
53-1003184-01
POST LED operation—Refer to
Normal LED operation—Refer to
"System LEDs"
"Port LEDs" on page 39
"POST-operation LEDs" on page 39
"Normal-operation LEDs"
shows the three system LEDs used on the Brocade 6545 16 Gbps FC Switch Module.
Table 5 for LED descriptions.
Switch system LEDs
LED
Switch status LEDs (Green/Amber)
Health LED (Green/Amber)
ID LED (blue)
shows the port LEDs used on the Brocade 6545 16 Gbps FC Switch Module. Refer to
for LED descriptions.
"POST-operation LEDs"
"Normal-operation LEDs"
on page 40
Description
Identifies switch behavior.
•
Green LED is lit when the Switch Module operates
normally and no errors have been detected. All
internal and external ports are ready for use.
•
Green LED is off when the Switch Module is powered
off or when power has failed.
•
Flashing Amber LED indicates a fault condition.
Locator ID. Controlled by the MMB.
Interpreting switch LEDs
on page 39
on page 40
4
39