Connecting The Embedded Switch Module Through Chassis; Management; Connecting The Switch Module To The Fabric - Fujitsu Brocade 6545 Gen5 Hardware Reference Manual

Connecting the Embedded Switch Module through chassis

management

The internal Ethernet connection is the default configuration and no action is required.
Figure 6
port.
FIGURE 6

Connecting the Switch Module to the fabric

NOTE
Refer to
procedure.
Before beginning the following steps, determine whether the Brocade 6545 16 Gbps FC Switch
Module is in Brocade Access Gateway mode or Fabric OS Native mode. This affects the
configuration process.
1. If the Switch Module is in Fabric OS Native mode, continue with
2. Log in to the Switch Module through a Telnet connection.
3. Modify the domain ID, if required, using Switch Module CLI commands. Refer to the "Domain
Brocade Gen5 6545 16-Gbps FC Switch Module Hardware Reference Manual
53-1003184-01
shows the default port control setting on the Fujitsu PRIMERGY BX900 S2 Management
Fujitsu PRIMERGY BX900 S2 Management Port Control defaults to Internal Port
"Cabling guidelines for fiber-optic cables"
Module is in Access Gateway mode, go on to
IDs" section of the Fabric OS Administrator's Guide for more information.
Connecting the Switch Module to the Ethernet network
on page 18 before beginning the following
step 4.
step 2 and step 3. If the Switch
3
27