Inserting Sfp+ Optical Transceivers And Cables - Fujitsu Brocade 6545 Gen5 Hardware Reference Manual

•
•
NOTE
A 50-micron cable should not be bent to a radius less than 1.5 inches (38 mm) under full tensile
load and 1.2 inches (30.5 mm) with no tensile load.

Inserting SFP+ optical transceivers and cables

NOTE
Be sure to use only Brocade-branded SFP+ optical transceivers. Unapproved products will not be
recognized.
Refer to
currently supported and the types of devices they support.
1. Review the section
2. Insert the SFP+ optical transceiver in an external port on the Switch Module until it is firmly
3. Review the section
4. Insert the fibre-optic cable in the integral SFP+ optical transceiver until the latching
Brocade 6545 Gen5 16-Gbps FC Switch Module Hardware Reference Guide
53-1003184-01
Tie wraps are not recommended for optical cables because they are easily overtightened.
Do not put excess weight on the cable at the connection point. Make sure the cable is well
supported.
Table 3 on page 18 for a list of Brocade-branded SFP+ optical transceivers that are
"Handling SFP+ optical transceivers"
seated and the latching mechanism clicks.
Transceivers are keyed to ensure correct orientation. If a transceiver does not install easily,
ensure that it is correctly oriented.
"Cabling guidelines for fiber-optic cables"
mechanism clicks.
Cable connectors are keyed to ensure correct orientation. If a cable connector does not install
easily, ensure that it is correctly oriented. For instructions specific to a cable type, refer to the
cable manufacturer's documentation.
The cables used in trunking groups must meet specific requirements. For a list of these
requirements, refer to the Fabric OS Administrator's Guide.
Inserting SFP+ optical transceivers and cables
on page 17.
on page 18.
2
19