Furuno FELCOM 250 Operator's Manual page 133

Group setting screen (Connection)
Click Connection on the Group setting screen to shown the Connection settings
screen. Enter connection settings as applicable.
Item
Auto Place a [ ] to connect automatically when power is turned on. Ap-
connection plicable to topmost item on the connection list (Standard/Browser).
Persistent Place a [ ] to automatically reconnect.
Auto • Place a [ ] to automatically disconnect.
disconnection • If applied, choose disconnect condition (Any Time, No Tx&Rx, No
• If applied, enter disconnect time (001 - 999).
Apply button Click to apply settings. If group is doing PS, changes are applied af-
ter completion of PS.
Cancel button Click to restore previous settings.
Group setting screen (Firewall)
Click Firewall on the Group setting. Use this screen to block unwanted communica-
tions. Set the screen according to application and system.
Item
Prohibit the routing of
NBT & MIcrosoft-DS
Refuse demand of
IDENT
Do not respond to
ping from WAN
Prohibit Windows-
Update
Apply button
Tx, No Rx)
Check to prohibit NBT and Microsoft-DS. The default setting is
"checked".
Disregard ping from WAN side. Place a [ ] to activate. The de-
fault setting is "checked".
Check [ ] to prohibit response to ping from WAN. Initial setting
is "checked".
Prohibit Windows-Update. Place a [ ] to activate. The default
setting is "checked".
Click to apply previous settings.
6. WEB FUNCTIONS
VPN pass-through
Description
VPN pass-through
Description
6-19