Compaq SP700 Reference Manual page 30

2-4 Compaq Setup and Diagnostic Software
Computer Setup Features
Set the power button configuration (on/off or
suspend/wakeup) and enable/disable power
LED blink in suspend mode
NOTE: This selection does not appear if the
energy saver mode is disabled.
Enable the Power-on Password. For more
information, see the section "Security
Management" in Chapter 3.
Enable/disable network server mode,
keyboard QuickLock, QuickBlank screen
when locked, and/or QuickLock in energy
saver mode. For more information, see the
section "Security Management" in Chapter 3.
NOTE: This selection appears only if a Power-
on Password is set.
Enable the Setup (administrator) Password.
For more information, see the section
"Security Management" in Chapter 3.
Enable/disable serial, parallel, and USB ports
and audio security
Set the Asset Tag and Ownership Tag. See
the section "Security Management" in
Chapter 3 for more information.
Set the keyboard locale setting (for example,
English or German) for the System ID entry
Enable/disable Network Service Boot
Enable/disable the SCSI controller boot order
for Compaq SCSI options
Set the POST mode (QuickBoot or FullBoot)
and enable/disable POST messages
Set resources for onboard system devices
(serial port, parallel port, etc.)
Continued
Task Computer Setup Selection
Select Power, then select Energy Saver
Options.
Select Security, then select Power-On
Password.
Select Security, then select Password
Options.
Select Security, then select Setup
Password.
Select Security, then select Device
Security.
Select Security, then select System IDs.
Select Security, then select System IDs.
Select Security, then select Network
Service Boot.
Select Advanced, then select SCSI
Controller Order.
Select Advanced, then select Power-On
Self Test.
Select Advanced, then select Onboard
Devices.
Continued