Compaq SP700 Reference Manual page 127

11-12 Troubleshooting
Solving Network Problems
Diagnostics passes, but
the workstation does not
communicate with the
network.
Network controller
stopped working when an
expansion board was
added to the workstation.
Continued
Problem
Network drivers are not
loaded, or driver parameters
do not match current
configuration.
The network controller is not
configured for this
workstation.
Network controller interrupt
overlaps the interrupt of an
expansion board.
Network drivers are not
loaded, or driver parameters
do not match current
configuration.
The cable is not securely
connected.
Network controller interrupt
overlaps the interrupt of an
expansion board.
Possible Cause Possible Solution
Make sure the network
drivers are loaded and
that the driver
parameters match the
configuration of the
network controller.
In Windows NT
Workstation, select the
Network icon at the
Control Panel.
Run the Setup utility and
modify the network
controller memory value.
Make sure the network
drivers are loaded and
that the driver
parameters match the
configuration of the
network controller.
Ensure that the cable is
securely attached to the
network connector and
that the other end of the
cable is securely
attached to the correct
device.
Run the Setup utility and
modify the network
controller memory value.
Continued