Standard Features - Compaq SP700 Reference Manual

1-2 Product Features

Standard Features

The Compaq Professional Workstation SP700 offers the following features.
Features may vary depending on your model. For a complete listing of the
hardware and software installed in your workstation, run the INSPECT utility
in Chapter 2.
Processors
Number of Processors
L2 Cache Size
PCI Bus
AGP Bus
Memory Controller
Memory
Optional Memory
Upgrades
Error Checking and
Correcting (ECC) Memory
Graphics Controller
Expansion Slots
Compaq Professional Workstation SP700 Standard Features
Feature
Standard with one 400-MHz or 450-MHz Intel Pentium II Xeon
processor
One processor, upgradable to two
512 KB
Dual-Peer PCI buses (aggregate bandwidth of 267MB/sec)
2x mode capable (533 MB/sec bandwidth) and supports
Side-Band Addressing (SBA)
Dual 64-bit memory controllers (aggregate bandwidth of
1.6GB/sec)
Up to 128-MB, 100-MHz ECC Registered SDRAM. All models
upgradable to 4 GB.
Supports 100-MHz ECC 32-MB, 64-MB, 128-MB, 256-, or
512-MB Registered SDRAM DIMMs. (Single DIMMs can be
inserted in any of the eight DIMM sockets.)
Uses an encoding scheme for memory error detection and
correction. (This feature detects and corrects all single-bit
memory errors, and detects and reports double-bit errors.)
Ships with 2D/3D or 3D graphics controller. See the
appropriate guide on the SmartStart for Workstations CD
under X:\DOCS\GRAPHICS, where X is your CD-ROM drive.
Nine slots with eight open: four dedicated full-length PCI slots,
one dedicated short PCI slot, one shared full-length PCI/ISA
slot, two dedicated short ISA slots, and one Accelerated
Graphics Port (AGP) slot located on system board.
Table 1-1
Compaq Professional Workstation SP700
Continued