Checking The Control Surface Movement - Hangar 9 Alpha 40 ARF Assembly Manual

Checking the Control Surface
Movement
Required Parts
Transmitter Assembled airframe
The control direction has been set at the factory. This
section has been provided in case any servos or control
surfaces are replaced so the control direction can be
checked at a later date.
ChECKINg ThE ELEvAToR
Check the movement of the elevator with the radio system.
Pushing the elevator/aileron stick (right stick on the
transmitter) forward will make the airplane elevator move
down. This will cause the aircraft to pitch down while in flight.
Check the movement of the elevator with the radio
system. Pulling the elevator/aileron stick (right stick on the
transmitter) back will make the airplane elevator move up.
This will cause the aircraft to pitch up in flight.
Hangar 9 Alpha 40 ARF Assembly Manual
ChECKINg ThE AILERoNS
Check the movement of the aileron using the transmitter.
When the aileron/elevator stick is moved left, the left aileron
will move up and the right aileron will move down. This will
cause the aircraft to roll left in flight.
Check the movement of the aileron using the transmitter.
When the elevator/aileron stick is moved right, the right
aileron will move up and the left aileron will move down.
This will cause the aircraft to roll right in flight.
ChECKINg ThE RuddER
Check the movement of the rudder using the transmitter.
When the left stick is moved left, the rudder should also
move left. This will cause the aircraft to turn left while on the
ground and to yaw left while in flight.
Check the movement of the rudder using the transmitter.
When the rudder/throttle stick (left side of the transmitter)
is moved right, the rudder should also move right. This will
cause the aircraft to turn right while on the ground and to
yaw right while in flight.
45