Hangar 9 Alpha 40 ARF Assembly Manual page 36


Step 9
Connect the clevis to the center hole of the rudder control
horn. Slide the safety tubing over the forks of the clevis to
prevent it from opening accidentally.
36

Step 10
Place the servo horn back on the rudder servo. Make sure
the horn is aligned correctly as described previously.

Step 11
Use a ruler to make sure the rudder is centered with the
fin. Use a felt-tipped pen to mark the pushrod wire where it
crosses the hole enlarged previously on the servo horn.
Attach clevis
to center hole

Step 12
Remove the rudder servo horn. Use pliers to bend the pushrod
wire 90-degrees at the mark made in the previous step.

Step 13
Slide the pushrod wire through the hole in the servo horn.
The horn will fit against the bend in the wire.
Hangar 9 Alpha 40 ARF Assembly Manual