Hangar 9 Alpha 40 ARF Assembly Manual page 35


Step 6
Place the small washer on the opposite side of the horn. The
connector is then secured using a small E-clip. Use pliers to
snap the E-clip in position.
Hangar 9 Alpha 40 ARF Assembly Manual

Step 7
Slide the 2-56 x 28-inch pushrod wire into the tube in the
fuselage for the rudder. Make sure the threaded end goes
into the tube first. Use a hobby knife and #11 blade to trim
the covering on the fuselage where the pushrod exits.

Step 8
Use a hobby knife to cut a 1/4-inch (6mm) piece from the clear
safety tubing. Slide the tubing onto the clevis, and then thread
the clevis 10-turns on the rudder pushrod wire as shown.
35