Wing Installation - Hangar 9 Alpha 40 ARF Assembly Manual

Wing Installation

Required Parts
Wing Fuselage
Rubber band (10)

Step 1
Locate the rubber band to secure the wing to the fuselage.

Step 2
Locate the aileron extension that is inside the fuselage. Align
the colors from the aileron servo lead with the extension so
they match, then plug them together.
44

Step 3
Start securing the wing to the fuselage by installing two of
the rubber bands.
hint: Always start with the cross rubber bands. This
will keep the wing from twisting on the fuselage when
installing the remaining rubber bands.

Step 4
Install a second set of rubber bands on the wing
as shown.

Step 5
Continue installing a total of six or more of the rubber bands,
alternating the direction of each set until they have all been
installed.
hint: Always end the rubber band installation by
installing the cross rubber bands last. They will help in
keeping all the other rubber bands in position on the
wing dowels.
hint: After flying, store your rubber bands in a bag with
a small amount of baby powder. This will soak up the fuel
that is on the rubber bands, making them last longer.
Hangar 9 Alpha 40 ARF Assembly Manual