Hangar 9 Alpha 40 ARF Assembly Manual page 30


Step 5
Once set, use pliers to make a 90-degree bend in the
pushrod wire at the mark made.

Step 6
Use a pin vise and 5/64-inch (2mm) drill bit to enlarge the
hole in the servo horn that has aligned for use with your
linkage position.
30

Step 7
Remove the servo horn from the servo using a #1 Phillips
screwdriver. Use diagonal cutters to remove any unused
arms from the horn so they don't interfere with the operation
of the servo.

Step 8
Slide the pushrod wire through the hole in the servo horn.
The horn will fit against the bend in the wire.

Step 9
Slide the pushrod snap link on the wire. Rotate the link so it
snaps on the wire. You may need to use pliers to snap the
link onto the wire.
Hangar 9 Alpha 40 ARF Assembly Manual