Canon GP215 Service Handbook page 30

STANDARDS AND ADJUSTMENTS
8 Checking the Photointerrupters
The photointerrupters may be checked either using a conventional tester or using service mode.
1. Using a Tester
1) Set the tester range to 12 VDC.
2) Connect the tester probe to GND (0 VDC) of the DC controller PCB.
3) Make checks as instructed.
2. Using Service Mode
1) Open the front door, and insert the door switch actuator into the door switch assembly; then, insert the
handle of the static eliminator cleaning brush into the fixing assembly releasing assembly.
2) Press the service switch.
3) Press the * key twice, and press 'I/O DISPALY' (*2*) to highlight; then, press the OK key.
4) Press the Page key to select the screen showing the desired address.
No.
Name
Tester probe
Service mode
Make checks; nor-
mal if as indicated.
Display reading
Tester reading
2–22
PS1
Scanner home posi-
tion sensor (SCHP)
J107-A2
—
Move the scanner
from home position
during standby.
The scan- The scan-
ner is at ner is not
home at home
position. position.
— —
about 5 V about 0 V
PS2
Fixing film sensor
(FFD)
J109-3
DC PA0-bit0
Move the detecting
lever by hand dur-
ing standby.
The light- The light-
blocking blocking
plate is plate is
present. absent
1 0
about 5 V about 0 V
PS3
Copyboard cover
open/closed sensor
(CBCC)
J113-B9
DC PA0-bit1
Open/close the
copyboard cover dur-
ing standby.
The copy- The copy-
board board
cover is cover is
closed. opened.
1 0
about 5 V about 0 V