Canon GP215 Service Handbook page 23

4 Registering the Multifeeder
Paper Width Basic Values
You must register the multifeeder paper width
basic values whenever you have replaced the
multifeeder paper width detecting VR.
1) Replace the paper width detecting VR.
2) Open the front door, and insert the handle of
the separation static eliminator cleaning brush
into the fixing assembly releasing assembly.
3) Insert the door switch actuator into the door
switch assembly.
4) Press the service switch with a hex key.
5) Press the * key twice.
6) Press 'FUNCTION' on the screen (*4*) to
highlight; then, press the OK key.
7) Press the Page key to bring up the Multifeeder
Paper Width Basic Values Registration
screen.
*4* FUNCTION 07
AD =xxxx
MF-A6R=xxx
MF-A4R=xxx
MF-A4 =xxx
SIZE =xxx.x (mm)
+
Figure 2-228
8) Set A6 paper in the multifeeder, and adjust
the side guide to A6R.
Note:
A6 is what is obtained by folding A4 paper
into four; the width is 105 mm.
9) When the side guide is adjusted to A6R, the
VR output value will be indicated under
'AD=xxx' on the screen.
After checking the value, press 'MF-A6R' on
the screen to highlight; then, press the OK
key.
• The value will be stored under 'MF-A6R'.
10) Likewise, set A4R paper in the multifeeder,
and adjust the side guide to A4R.
CANCEL
–
OK
STANDARDS AND ADJUSTMENTS
11) Check that the value of 'AD' is indicated; then,
press 'A4R' to highlight, and press the OK
key.
• The value will be registered under 'A4R'.
12) Set A4 paper in the multifeeder, and adjust
the side guide to A4.
13) Check that the value of 'AD' is indicated; then,
press 'A4' to highlight, and press the OK key.
• The value will be stored under 'A4'.
14) Press the Reset key twice to end service
mode.
15) Turn off and on the main power switch.
A4
A4R
A6R
A6R
(105mm) (210mm)
Paper width →
Figure 2-229
A4R A4
(297mm)
2–15