Table of Contents
Advertisement
5012-91 Installation Manual
3.
4.
5.
6.
7.
To un-restrain the elevation axis of the
antenna, unthread the two hex nuts. Using a
¾" open end wrench, remove the hex nuts
and washer from the stow pin-bolt.
Remove the stow pin-bolt from the bracket.
Remove the washer from the stow pin-bolt
and thread one of the two hex nuts onto the
bolt and tighten.
Put one of the washers onto the stow pin-bolt
and insert it into the bracket toward the
elevation driven sprocket.
Put the other washer, and then the other hex
nut onto the bolt.
17-6
Stowing the Antenna
Advertisement
Table of Contents
