Ku-band broadband-at-sea vsat antenna system (138 pages)
Summary of Contents for Sea Tel SERIES 10
Page 1
Southampton, UK S0 18 2HJ Fax: (925) 798-7986 Tel: 44 (0)23 80 671155 Email: seatel@cobham.com Fax: 44 (0)23 80 671166 Web: : www.cobham.com\seatel Email: seatel@cobham.com Web: www.cobham.com\seatel Sea Tel Inc doing business as Cobham SATCOM July 30, 2010 Document. No. 132054 Revision A...
Page 2
The Sea Tel Series 09 & 10 antennas will meet the off-axis EIRP spectral density envelope set forth in FCC 47 C.F.R. § 25.222(a)(1) when the input power density limitations, listed in our FCC Declaration, are met..
Scheduled Preventive Maintenance Series 10 Broadband At Sea Scheduled Preventive Maintenance 1.1. Lowest Replaceable Unit Locations 1 Radome Base and Top 8 BUC Power Supply 2 Motor Junction Enclosure 9 Pedestal Control Unit (PCU) 3 Block Up Converter (BUC) 10 Elevation Motor and Belt...
Series 10 Broadband At Sea Scheduled Preventive Maintenance 1.3. Bi-Annual Operator Checks Record your Inspections in the Maintenance Record pages at the end of this manual. 1.3.1. Test GPS Auto-Update This verifies that the GPS position information is automatically updating.
1.4. Bi-Annual Inspections Regular inspections will assure that your antenna is in peak operating condition. Your Sea Tel authorized dealer has trained service technicians who will perform this work using Sea Tel replacement parts. Record your Inspections in the Maintenance Record pages at the end of this manual.
Series 10 Broadband At Sea Scheduled Preventive Maintenance isolators, notify your dealer immediately to obtain replacements and replace all 4 wire rope isolators immediately (refer to the “replacing the wire-rope isolators” procedure in the Maintenance section of this chapter). 1.4.4.
Scheduled Preventive Maintenance Series 10 Broadband At Sea Inspect the belt teeth for damage. Look for teeth that have de-laminated from, or been completely torn off, of the belt. Check the motor cable for damage and that the retaining screws are tightened to keep the connector properly terminated.
Series 10 Broadband At Sea Scheduled Preventive Maintenance 1.4.7. Elevation Drive Component Inspections Inspect the Elevation Motor and belt. Assure that there are no loose motor mounting hardware. Check the motor cable for damage and that the retaining screws are tightened to keep the connector properly terminated.
Operator Troubleshooting 2.1. Warranty Information Sea Tel Inc. supports its Series 09 & 10 systems with a TWO year warranty on parts and a ONE year warranty on Labor. What’s Covered by the Limited Warranty? The Sea Tel Limited Warranty is applicable for parts and labor coverage to the complete antenna system, including all above-decks equipment (radome, pedestal, antenna, motors, electronics, wiring, etc.) and the Antenna Control Unit...
Page 14
Series 10 Broadband At Sea Operator Troubleshooting...
Page 15
Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date...
Page 16
Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date Bi-Annual date...