Table of Contents
Advertisement
5012-91 Installation Manual
The wizard will save the newly defined, or selected
preset satellite information to the systems INI file
Upon successfully saving the above information, the
system will automatically begin to the process of
targeting and/or searching for the preset satellite.
NOTE: If the satellite modem is not connected, or is
not setup correctly, the system may not be able to find
and lock on the satellite. In this case, you will have to
exit the wizard and (later) star over.
20. After the system has reported that is has
located and identified the desired satellite
select "Auto" to calibrate the Azimuth and
Elevation angular values.
Note: Systems, with IMA software ver 105 installed, and
with accurate gyro compass input, will calibrate both
Relative and True North Azimuth values simultaneously.
The wizard will save the calibration parameters to the
systems INI file
21. Once completed, the wizard will display the
Elevation and Azimuth Trim values calculated
and saved in the step above.
22. Click on "Auto" to set the auto-threshold value
for the system.
The wizard will calculate the required Threshold Offset
parameter value used for setting the actual AGC
threshold.
Once calculated, the wizard will save the Threshold
Offset parameter to the systems INI file.
Setup – Using the Commission Wizard
5-6
Advertisement
Table of Contents
