Table of Contents
Advertisement
Setup – Using the Commission Wizard
23. Once completed, the wizard will display the
Threshold Offset parameter value calculated
and saved in the step above.
Next is the sub-procedure for performing
commissioning tests with the Network. You need to
contact your service provider to arrange to do these
tests. The technician at the network will guide you
through a process of operating the modem and the MXP
to do pure carrier settings in the modem, adjusting
modem power output up to P1Db and adjusting the
polarity angle of the feed (from the MXP) to optimize
cross-pol isolation.
While communicating with the network and under the
direction of the network technician, perform Cross Pol
Isolation and 1Db compression tests.
24. Re-enter the wizard, return to this step and
Select "Perform Test"
25. Because you have already completed these
tests, Click on "Next".
This section allows you to download the "commissioned
state" INI file to a location of your choice (i.e. USB
Drive, hard drive, LAN Location, etc.)
26. Click on "Download".
27. Select to either Open or save the file to a
location of your choice.
28. Click on "Finish".
This will take you back to the System Configuration
screen. Once there, you may continue to use the
system in normal operation.
5-7
5012-91 Installation Manual
Advertisement
Table of Contents
