Figure 50: Gui "Array Initializing Percentage - Accusys ExaSAN A08S3-PS User Manual

Performance evaluation – Select to evaluate the performance of the target array. Data and
parity are not initialized. (No data protection when this mode is on).
Note
Once you click Create Array and you have selected On-the-fly
initialization, you will see the initializing % on the Main screen.
You will be able to use and configure the array immediately if it is
created using On-the-fly initialization. However, the RAID performance
of the array will be slightly lower than usual before the initialization is
complete.
Assign LUN automatically
Check this box to automatically assign a LUN. You may choose to assign LUN manually under
Options. However, you will not be able to use the RAID volume until it has been assigned a
LUN.
Click Create Array to complete the process.
Note
If you attempt to create a RAID set without meeting the minimum
required number of hard disk drives, and error message will pop up
after clicking Create
User Guide
.
Array

Figure 50: GUI "Array initializing percentage"

4. How to Use
Page 4-14