Table of Contents
Advertisement
2.
Preparing to Install ExaSAN A08S3-PS
To ensure safe and smooth operation of your ExaSAN A08S3-PS, it is essential that you
choose an appropriate location for the system, provide an appropriate operating environment,
and adequate power for all components of the system. As you plan for installation, follow the
guidelines below to ensure that the system and its environment are safely and appropriately
positioned for efficient operation and service.
2.1 Precaution for Handling the System
Take the following precautions to avoid damage to the system or potential injury to you.
1. Prepare a flat, sturdy surface before removing the system from its packaging. The table or
cart that will hold the system should be as close as possible to the system carton.
2. Ensure that all power switches have been turned off and all power cords disconnected to
prevent personal injury and damage to the hardware.
3. Static electricity can damage electronic components of your system. Follow the guidelines
below to avoid such damage:
a. Work in a static-free environment
b. Wear a grounded anti-static wrist strap
c. Store uninstalled components in anti-static bags
d. Handle circuit boards by their edges and avoid touching chips and connectors
2.2 Choosing the Location for the System
The ExaSAN A08S3-PS is designed as a small form factor or desktop solution. Depending on
where your desk or other install location is, you should keep the following points in mind when
determining where to place your system.
1. Measure the amount of available space on your desk. The amount of space required for the
A08S3-PS is 502mm(length) x 291mm(width) x 557mm(high)
2. Measure the distance between any two components that need to be connected via cable(s).
This measurement will help you determine the length of the required cable(s). Or if you've
already purchased the cables, determine the proximity of the components in question.
3. Leave sufficient room, at least two inches, around the unit to allow air ventilation.
4. Do not block or cover any of the ventilation holes in the front and back panels of the unit.
Consistent airflow is essential to keeping the system operating efficiently.
5. Allow additional room at the front and back of the unit for service.
6. The ExaSAN A08S3-PS uses several cables and cords. It's a good idea to determine how
they will be arranged at the rear of the system, and where the cables will be routed to
connect to the host systems and RAID disk systems.
2.3 Electrical Power
At your chosen location for the ExaSAN A08S3-PS, make sure that the electrical circuitry and
power outlets are sufficient for the combined power needs of all hardware components. To plan
for safe and adequate power to the system, follow these guidelines:
1. Check the documentation for all hardware components at the chosen location to determine
their power requirements. Then make sure that the available power supply for that location
is sufficient for the planned components.
2. When possible use surge protectors or power conditions as part of the installation.
3. When planning for electrical power, make sure you have more power than the total power
requirements specified for all components. Also make certain that the power load is
User Guide
2. Preparation
Page 2-1
Advertisement
Table of Contents
