Table of Contents
Advertisement
3. Installation
3.
Installing the ExaSAN A08S3-PS
Follow the steps in this chapter to prepare your ExaSAN A08S3-PS system for installation.
3.1 Installing the System
Follow the instructions in this section to hook up all your hardware components of the ExaSAN
A08S3-PS system. Do not turn the power of any individual component on until instructed. When
all components are properly connected, follow the instructions in section 3.3.1 "Powering On" to
turn the components on in the prescribed order.
3.1.1 Installing Disk Drives
Follow the steps below to install your HDDs. .
1. With the connectors facing outward, insert the HDD into the disk tray. (PCBA on the bottom)
2. Slide the HDD outward until the connectors align with the edge of the disk tray.
3. Secure the HDD to the disk tray with four screws from the bottom.
Figure 13: Mounting screws on tray
4. Slide the disk tray into the disk bays on the back of the chassis.
Figure 14: Insert tray into A08S3-PS
5. Push the tray inward until the tray firmly connects and you hear the tray click into place.
6. Repeat for all drives to be installed into the A08S3-PS.
User Guide
Page 3-1
Advertisement
Table of Contents
