Setting Up Ipl To Receive The File - Symbol PDT 8100 Series Product Reference Manual

3. If the correct hex file is not displayed in the Hex File to Load field, click on the
Browse button and navigate to the correct hex file to be downloaded.
4. Click on the Comm Port drop-down menu and select the COM port being used.
Ports already in use display in the Unavailable Ports field.
5. Click on the Baud Rate drop-down menu and select the appropriate baud rate.
Your options are 2400, 4800, 9600, 19200,38400, 57600, 115200.
6. On the Protocol drop-down menu, select None.
7. Click OK to load the file, or Multiple Hex File Download if more than one file
is being loaded.

Setting Up IPL to Receive the File

To set up IPL on the terminal to receive the files being downloaded via TCM:
1. Cold boot the terminal by pressing the reset button inside the battery compartment
while holding down the Function button.
2. Press and hold any Trigger (Scan) button. While holding down the Trigger (Scan)
button, press and hold the battery door switch inside the battery compartment (on
the left). This all must occur within 3 seconds after resetting the terminal.
Configuring the Terminal
12-13