Symbol PDT 8100 Series Product Reference Manual page 28

PDT 8100 Series Product Reference Guide for Pocket PC 2002
2. Connect the cradle to your computer by plugging the serial cable into the serial port
on the back of the cradle, and the other end of the cable into the serial port on your
computer.
Figure 1-7. Connecting the Cradle to the Host Computer
3. Insert the PDT 8100 terminal in the cradle.
Figure 1-8. Inserting the Terminal in the Cradle
4. The Terminal Status LED turns red (may take up to one minute) to indicate
charging. When the terminal battery is fully charged, the Terminal Status LED turns
green if the cradle is connected to a host PC by serial cable.
Note: If the cradle is not connected to a host PC via serial cable, the
Terminal Status LED flashes red twice and goes out when the
battery is fully charged.
1-10
Serial Port
Terminal Status LED