Epson TM-C3500 Series Technical Reference Manual page 33

Media type
Media source
Paper width
Black mark width
Black mark length
Center of a black mark
Gaps between black marks
Paper thickness
Gaps of perforated line
Form of perforated line
Number of folds
 Do not use the paper with a hole or cutout.
 Autocutting on the perforated lines may generate minute paper dust, causing machine
problems. Also, autocutting ahead of the perforated line may cause problems when
feeding paper. Therefore, autocutting must be performed 0.5 mm to 1 mm {0.02 to
0.039"} behind the perforated line.
 Black marks must position away at least 0.5 mm {0.02"} from the perforated line.
 The perforated lines on both sides of the paper edge must be left uncut.
 Make sure to keep the same position of the black marks to the perforated lines (position
that can be detected by black mark sensor) when inserting the paper from either side in
order to use the paper inserting from reverse direction.
Plain / Matte
Fanfold paper
50 to 108 mm {1.97 to 4.25"}
13 mm {0.51"} or more
5 mm {0.19"} or more
8.5 mm  1 mm {0.33  0.039"}
15 to 304.8 mm {0.59 to 12.0"}
0.124 to 0.128 mm {0.0047 to 0.005"}
203.2 to 304.8 mm {8 to 12"}
Plain media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut
Fine media : 1 mm {0.039"} uncut, 5 mm {0.2"} cut
PET film : 0.6 mm uncut, 8.4 mm cut
500 or less
Chapter 1 Product Overview
33
1