Table of Contents
Advertisement
Egress Tagging Rules
Egress Tagging rules are used to make change to the packet before it is stored into egress queue of an egress
port. The egress settings are provided for each port and are described as follows:
Egress Settings
Insert Tag (per port setting)
Enable -
Insert the Tag data of the associated Packet Tag information into the packet
Disable -
No tagging is performed.
Untagging Specific VID (per port setting)
Enable -
No tag insertion if the VID data of the associated Packet Tag information matches the Untagged
VID configured in next setting even [Insert Tag] is enabled.
Disable -
This rule is not applied.
Summary of VLAN Function
VLAN Modes (Configuration methods)
Port-based VLAN Mode: Simple UI to configure Port-based 2-VLAN-groups
Port-based VLAN ISP Mode: Simple UI to configure Port-based 7-VLAN-groups
Simplified VLAN Mode: Simple UI to configure Tag-based VLAN
Advanced VLAN Mode: Full VLAN configuration for port-based and Tag-based VLAN
VLAN range supported: 1 ~ 4095 (eight VLANs at the same time)
[PVID] [VID] [Untagged VID] value range: 1 ~ 4095
-66-
Advertisement
Table of Contents
