Panel Mounting; Figure 4-8: Arm Mounting (Arm-11-Rs) - IEI Technology AFL2-12A-HM65 Series User Manual

AFL2-12A-HM65 Series Panel PC
Step 4: Secure the flat bezel panel PC to the interface pad by inserting four retention
screws through the bottom of the mounting arm interface pad and into the flat
bezel panel PC.

Figure 4-8: Arm Mounting (ARM-11-RS)

4.8.2 Panel Mounting

To mount the AFL2-12A-HM65 into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the flat panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.
Step 0:
Page 33