Table of Contents
Advertisement
Connecting the Mediamaster
The Mediamaster receiver should have the following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART cable (fully connected, 1.0 meter)
• a mains cable
• an RF cable
• a User Guide and a software license agreement
The SCART sockets
The rear panel of the Mediamaster contains 2 SCART sockets (see
diagram). When you connect other devices to any of these sockets,
always use fully connected SCART cables (as supplied). There are
SCART cables on the market whose pins are not all operational and
your picture quality could be reduced if they are used.
Preparing the remote control
• Remove the cover from the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries, as shown in the diagram. Make
sure that you observe the + and - markings indicated inside.
Replace the cover
About digital transmission
Digital Radio and TV signals can be blocked by buildings, mountains
and the terrain. Depending on if the receiver is located in a depres-
sion in the ground, behind a mountain or in a concrete building, the
quality of reception may vary considerably. A digital signal can be
"boosted" if reflections of it (from e. g. a building) are added to the
original signal. Reflections can be used for reception by directing
the aerial towards a mountain or a high building, providing that
they do not block the transmitter. As with most other transmis-
sions, bad weather does affect the reception quality negatively.
GB 8
Mains
Remote
cable
control
SCART cable
RF cable
Scart socket
User
Guide
Advertisement
Table of Contents
