If you need to contact your Service Provider or a Service Centre, they
may ask for information available from this menu.
This gives general information about the hardware and software
version on which your Mediamaster is running.
This menu might appear when you use a CA module.
From the menu, you will get information related to your Service
To open this menu, you will be asked to enter your access code.
The access code is set to 1234 at the factory.
A channel search procedure can be performed in different ways:
Automatic, Manual or Advanced manual search.
• Highlight the line and press ok to start searching for channels.
When you perform a Manual search you first need to enter some pa-
rameters for the channel search to work.
The information you need to enter in this menu should be supplied
by your Service provider.
• Channel: Select the channel you want to search for.
• Network search: Select "Yes" if you want to search on all trans-
mitters connected to a specific network.
• Press ok to start searching for channels