Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected; 1,0 metre)
• mains cable
• RF cable
• Owner's manual with software license agreement
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other devices to any
of these sockets, always use fully connected SCART cables (as
the one supplied.) There are SCART cables available which do not
have all the pins connected. The picture quality could be reduced
if you use them.
Preparing the remote control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA; 1,5 V batteries, as shown in the diagram, tak-
ing care to observe the + and - markings indicated inside.
• Replace the cover.
GB 12
SCART cable
RF cable
Remote control
Owner's Manual
SCART socket
Mains cable