Table of Contents
Advertisement
INSTALLATION OF THE MEDIAMASTER
The box for your Mediamaster should contain the following
items:
• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected 1.0 metre)
• mains cable
• phone cable with connectors
• owner's manual with software license agreement
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see picture). When you connect other devices to any of
these sockets, always use fully connected SCART cables (as
supplied). There are "less well specified" SCART cables on the
market and picture quality could be reduced if you use them.
Preparing the remote control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1.5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
Connecting the Mediamaster to the dish
If you need to fit the F-connectors onto the cable
• Prepare each end of the cable as shown in the picture. You will
need to fold back the outer braid (as shown).
• Slide the F-connector onto the cable, then turn it clockwise
until it grips the braid.
• Ensure that 3 mm of the core is protruding from the end of the
connector.
Installing the satellite dish
• See the "Fitting instructions provided with your satellite dish"
on how to install the dish.
• Connect the coaxial cable, with F-connectors fitted, from the
LNB on the satellite dish to the socket marked "ANTENNA"on
the rear panel of the Mediamaster.
General
There are many different types of TV/VCR and other equipment
that you can connect to the Mediamaster.
In this manual you will see some of the most common ways to
connect your equipment.
If you have problems with your connections and need help, con-
tact your dealer.
GB 12
Phone cable
Mains
with connectors
cable
SCART socket
15 mm
8 mm
F-connector
3 mm
Remote
control
SCART
cable
Advertisement
Table of Contents
