Connection Of The Mediamaster; Preparing The Remote Control; Connecting The Mediamaster To The Dish - Nokia MEDIAMASTER 9780 S Owner's Manual

CONNECTION OF THE MEDIAMASTER

The box for your Mediamaster should contain the
following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART lead (fully featured 1,0 metre)
• a mains lead
• an aerial/RF lead (double screened 1,5 metres)
• a cable to the telephone
• an Owner's Manual (this document)
• a Software License agreement
• a quick guide
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other products to
any of these sockets, always use fully featured SCART leads
(as supplied). There are "less well specified" SCART leads on the
market and picture quality could be reduced if you use them.

Preparing the Remote Control

• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.

Connecting the Mediamaster to the Dish

If you need to fit the F-connectors onto the cable
• Prepare each end of the cable as shown in the diagram. You
will need to fold back the outer braid (as shown).
• Slide the F-connector onto the cable, then turn it clockwise
until it grips the braid.
• Ensure that 3 mm of the core is protruding from the end of the
connector.
Installing the Satellite Dish
Connect the coaxial cable, with F-connectors fitted, from the LNB
on the satellite dish to the socket marked "ANTENNA"on the rear
panel of the Mediamaster.
GB 8
SCART lead RF lead
Remote Mains Owner's manual
control lead License agreement
Quick guide
SCART socket
15 mm
Phone
cable
8 mm
F-connector
3 mm