Chapter 3 Initial Setup
3.1 Inserting a CompactFlash Card
UNO-3072A/3074A provides two CompactFlash slots. One slot (CF2) on
the daughterboard is accessible from the top of the system, where you can
insert your CompactFlash card directly. The other slot (CF1) is inside
UNO-3072A/3074A on its motherboard. You can set SW3-1 to decide
which one is the master.
SW3-1 on motherboard (refer to Figure A.4)
OFF: External CF master (CF1 Slave, default)
ON: External CF master (CF1 Slave)
Note: Only one CompactFlash can be set as master
Internal & external CompactFlash doesn't support Hot Swap
Needs to use " Fixed Disk Mode" CompactFlash to install OS
Following is the procedure for the installing a CompactFlash card in the
internal slot (CN3) of your UNO-3072A/3074A. Please follow these
steps carefully:
1.
Remove the power cord.
2.
Unscrew the four screws from the top cover of UNO-3072A/
3074A.
3.
Remove the top cover.
4.
Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot on mainboard.
5.
Screw back the top cover with four screws.
3.2 Connecting Power
Connect the UNO-3072A/3074A to a 10 ~ 36 V
power source can either be from a power adapter or an in-house power
source.
UNO-3072A/3074A
User Manual
DC
42
power source. The