Table of Contents
Advertisement
6.
Press Enter to confirm your controller and continue. At this point,
you have successfully installed the driver and Windows setup
should continue. Leave the floppy disk in the floppy drive until the
system reboots. Windows setup will need to copy the files again
from the floppy to the Windows installation folders. Once Win-
dows setup has copied these files again, remove the floppy disk so
that Windows setup can reboot as needed.
7.
During Windows setup, create a partition and file system on the
RAID volume as you would on any physical disk.
Note: If you wish to use the Intel Rapid Storage Technology user
interface in Windows, you will need to install Intel Rapid Storage
Technology by running the Setup.exe process after these steps have
been completed and the operating system has been successfully
installed.
39
Chapter 2
Advertisement
Table of Contents
