Initial Setup; Connecting The Power Cord; Connecting The Mouse And Keyboard; Activating The Power Source - Advantech USC-250 User Manual

2.1 Initial Setup

2.1.1 Connecting the Power Cord

This product only supports DC power (12 V
when plugging or unplugging the power cord.

2.1.2 Connecting the Mouse and Keyboard

Connect the mouse and keyboard via the USB ports located in the I/O section at the
rear of the computer.

2.1.3 Activating the Power Source

Verify that the power cord is connected to the power input port of the device and the
plug end is connected to the power supply outlet. Then press the Power button of the
device to initiate boot up.

2.2 Jumper Settings

The table below lists the function of each of the board jumpers. Instructions for set-
ting jumpers and connecting external devices to the motherboard are provided in
subsequent sections of this chapter.
Table 2.1: Jumper Settings
Label
JP4
JP6
JCASH1
CN24
JP4: Pin 1-2: TPM 1.2, Pin 2-3: TPM 2.0 (default)
JP6: (This jumper allows users to clear the real-time clock (RTC) CMOS RAM.)
Pin 1-2: Normal (default), Pin 2-3: Clear CMOS
JP_CASHV1: Pin 1-2: 12 V, Pin 2-3: 24 V
CN24: (This jumper allows users to set the COM port power mode) Default: RI
Note: PCB silkscreen " ▽ "mark Pin 1.
Is
To
create
space
USC-250 User Manual
, 84 W). Be sure to hold the plug end
DC
Function
TPM compatibility
Clear CMOS
Cash drawer power select
COM 1 and COM 2 /+5 V/+12 V select
This
6