Setting Up The Base And Charger (If Included); Connecting The Base - Siemens Gigaset S790 Manual

Gigaset S790/S795 / USA-CAN EN / A31008-M2121-R301-1-3S19 / starting.fm / 28.07.2009
First steps

Setting up the base and charger (if included)

Connecting the base

10
The base and charger are designed for use in dry rooms in a temperature range
of +41°F to +113°F.
¤
Set up the base at a central point in the building on a level, non-slip surface
or mount the base (Gigaset S790 only)
Please note
Pay attention to the range of the base.
This is up to 984 feet
inside buildings. The range is reduced when Eco Mode (
activated.
The phone's feet do not usually leave any marks on surfaces. However, due to
the multitude of different varnishes and polishes used on today's furnishings,
the occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight
or other electrical devices.
u
Protect your telephone
¤
First connect the
power adapter 1.
¤
Then connect the
telephone jack
2
and insert the
cables into the
cable ducts.
Please note:
u
The power adapter must always be connected, as the phone will not oper-
ate without.
u
Use only the power adapter and phone cord supplied. Pin connections on
telephone cables can vary (
or charger on the wall (
in unobstructed outdoor areas and up to
from moisture, dust, corrosive liquids and fumes.
1
2
¢
page 63).
¢
page 60).
165 feet
¢
page 43) is
1
1