Tf85 Tape Drive - DEC Rackmount 7000 AXP Installation And Owner's Manual

5.3.15 TF85 Tape Drive

Perform the following procedure to remove the TF85 tape drive:
Before performing the following removal and replacement
procedures, switch off the circuit breakers on the back of the
XMI chassis and on the power controller.
1. Extend the XMI chassis for service (see Section 5.3.2).
2. Remove the top cover (see Section 5.3.3).
3. Remove the four screws that secure the RRD42/TF85 option cage to the right
side of the chassis.
4. Tilt the rear of the RRD42/TF85 option cage upward and disconnect the two
connectors from the back of the TF85.
5. Push the two connectors from the back of the TF85 back through the access
slot located on the rear of the RRD42/TF85 option cage.
6. Tilt the RRD42/TF85 option cage upward at the rear and lift the cage out.
7. Remove the four screws (two at the top and two at the bottom) that secure
the TF85 tape drive in the option cage.
8. Slide the TF85 tape drive out of the option cage.
To replace the TF85 tape drive, reverse steps 1 through 8.
Removal and Replacement
WARNING
Removal and Replacement 5–59