Table of Contents
Advertisement
Option Installation
3. Remove the top cover (see Section 5.3.3).
You must wear an antistatic wriststrap attached to the chassis
when handling any modules.
4. Put on the antistatic wriststrap. This strap is contained in the plastic pouch
located on top of the power supply modules.
5. Select the slot where the option card is to be installed and lift the lever to
open the chosen slot. Figure A–1 shows the slot designations of the XMI card
cage as viewed from the top front of the chassis.
6. Align the option card with the chosen slot and slide the card down into the
slot until it stops.
7. Lower the lever to lock the card into the slot.
8. Replace the top cover.
9. Proceed to Section A.3 and perform the cabling of the option.
A–2 Option Installation
CAUTION
Advertisement
Table of Contents
Troubleshooting
