Installing The Equipment Mounting Slides - DEC Rackmount 7000 AXP Installation And Owner's Manual

Figure 2–4 Installing the Equipment Mounting Slides (Rear View of Left Slide
with Slide Extended)
c. Install the other two screws in the top and bottom holes of each slide
support bracket at each end of the slide.
Do not install a screw in the top hole (hole 5) of the right front
slide support bracket. This hole must be left open to allow room
for the clip that secures the front bezel to the chassis.
d. Tighten all eight screws (seven on the right slide) to secure each slide.
Pull the slide upward when securing it to the rails. Also, ensure
that the slide is level.
5. Tighten the two screws that secure the rear slide bracket to the slide.
6. Install two U-nuts on the right front rail over the 8th and 27th holes up from
the datum line by sliding them over the edge of the rail and aligning them
with the holes (see Figure 2–3). These are used for securing the LSB chassis,
in the closed position, to the rail.
Bar Nut
Positioned
Behind Bracket
MK233911
NOTE
NOTE
Installation
Installation 2–9