Removal and Replacement
5.2.2 Extending the LSB Chassis for Service
Before extending the LSB chassis for service, ensure that the
cabinet is stable and that all provided stabilizing features have
been activated. The stabilizing features for the rack or cabinet
are configuration dependent.
Perform the following procedure to extend the LSB chassis for service:
1. Extend the stabilizing legs at the front of the cabinet (if stabilizing legs are
provided).
2. Remove the LSB front bezel (see Section 5.2.1).
3. Remove the XMI front bezel (see Section 5.3.1).
Failure to remove the XMI front bezel before extending the LSB
chassis will cause the XMI front bezel to fall and may result in
personal injury.
4. Remove the four retaining screws that secure the chassis to the front rails
(see Figure 5–2).
Check and ensure that all cables are free to follow the chassis
before extending the chassis.
5. Carefully pull the LSB chassis forward until the slides lock in the extended
position.
To secure the chassis in the cabinet, press in on the left and right slide locks and
reverse steps 1 through 5.
5–4 Removal and Replacement
WARNING
WARNING
CAUTION