Removing The Touch Panel From The Backbox After Wall Installation - AMX MST-1001 Instruction Manual

Installing Wall-Mount (MXD) Panels

Removing The Touch Panel From the Backbox After Wall Installation

Occasionally it may be necessary to remove the touch panel from the wall to perform routine maintenance, firmware
upgrade or troubleshooting. This section describes the best methods for removing to touch panel from the Backbox
without damaging either.
1.
With fingertips placed on the top edge of the bezel, press down on the panel firmly but gently to unhinge the top
clips of the Backbox. Do not press on the glass!
Always push down on the frame of the touch panel. NEVER push on the glass.
2.
Once the top clips are release from the touch panel, pull the top panel away from the wall and lift the touch panel up
to separate it from the Backbox. Do not pull on the cables.
3.
Unplug the cables if the touch panel needs to be removed for maintenance.
4.
To reattach the panel to its Backbox, latch the panel onto the top hooks on the Backbox and push it down onto the
bottom snaps. Press gently but firmly on the ends until the snaps "click" to lock it down.
38 Modero S Series G4 Touch Panels Instruction Manual