Table of Contents
Advertisement
0009
0010
0011
0012
0013
0014
0015
0016
Thin Client User's Guide
Non-numeric data was attempted to be entered into a
numeric only field. Valid characters are 0-9, a blank, a
comma, a period, and a hyphen.
Press RESET and use valid characters.
Data was entered into a field that will only accept signed
numeric data. Valid characters are 0-9.
Press RESET and use valid characters.
Data was entered into the last position of a signed numeric
field.
Press RESET and make sure that the data is correct. Exit
the field by using the Field -, Field +, or Field Exit keys.
The cursor is either in the last position of the field or there
are no spaces in the field.
Press RESET. Correct the field, if necessary. The insert
key may not be used to change data or to enter the last
character into the field.
After pressing the Insert key, you attempted to leave a field.
Press RESET.
A key function was pressed that moves the cursor out of
the field. However, the requirements of the mandatory-fill
field have not been met. (Mandatory-fill fields must be filled
completely or left blank.)
Press RESET and enter data to fill the entire field, or move
the cursor to the start of the field and use the Field -, Field
+, or Field Exit keys to blank out the entire field.
Data was entered in the self-check field. The number and
the digit you just entered do not correspond.
Press RESET and verify numbers entered. If numbers are
valid, but error still occurs, contact your systems
administrator.
The Field – key was pressed, but you are not in a numeric
field.
Press RESET and continue to enter data. Press Field Exit
to blank the field.
Troubleshooting
126
Advertisement
Table of Contents
