Table of Contents
Advertisement
Step Four: Connect to the Server
Connect a 10/100Base-T cable from the network outlet of the thin client to a hub.
N
: B
OTE
AND THAT NO POWER IS BEING SUPPLED TO THE THIN CLIENT
Step Five: Start the Thin client
To start the thin client, connect the external power supply to the wall outlet and press the On/Off switch
located on the front panel. Refer to the Setup the Thin Client section for instructions to setup the thin
client software.
N
: W
OTE
O
/O
THE
N
AUTOMATICALLY RESTART WHEN THE SUPLY OF POWER RESUMES
Status of LEDs on the Front and Rear Panels
The front panel of the thin client has two LEDs on the right and left side of the On/Off switch.
The Power-LED on the left side glows green when the unit is switched on and remains on until the
unit is switched off.
The Internal Storage Access LED on the right side flickers red when the thin client is accessing the
thin client's firmware or locally stored applications such as Internet Explorer.
The rear panel of the thin client has two LEDs next to the Network connector.
The green LED flashes when the thin client communicates at 100 Mbps and blinks slowly when
communicating at 10 Mbps.
The yellow LED turns on only when the thin client communicates at 10 Mbps.
N
: T
OTE
MOTHERBOARD AS ALONG AS THE POWER TRANSFORMER IS CONNECTED
(
POWER
ONLY USES
Thin Client User's Guide
EFORE CONNECTING ANY CABLE
Host 1
Host 2
ICA Server
HEN THERE IS A POWER INTERRUPTION TO THE EXTERNAL POWER SUPPLY
FF SWITCH ON THE FRONT PANEL TO START THE UNIT
,
HE THIN CLIENT
LIKE THE CURRENT
LED
ON THE FRONT IS OFF
1
(
WATT OF POWER
WHEN ON AND RUNNING
,
ENSURE THAT EXTERNAL POWER SUPPLY IS DISCONNECTED
.
Workstation
Ethernet
10/100Base-T
Thin Client
HUB
PC
,
S
ALWAYS HAS POWER APPLIED TO THE
,
E
BUT THE GREEN
THERNET
,
THE THIN CLIENT USES
Install the Thin Client
,
YOU MUST PRESS
. T
HE THIN CLIENT WILL NOT
.
. I
N THE STAND BY CONDITION
LED
),
WILL BE ON
THE THIN CLIENT
20
WATTS
).
11
Advertisement
Table of Contents
