Installing The New Hot-Plug Power Supply Unit; Concluding Steps - Fujitsu PRIMERGY RX4770 M1 Upgrade And Maintenance Manual

Power supply units
6.4.3

Installing the new hot-plug power supply unit

Figure 16: Installing the hot-plug power supply unit
Ê Push the power supply unit into its slot (1) as far as it will go until the locking
latch snaps in place (2).
V
CAUTION!
Ensure that the power supply unit properly engages in its slot and is
locked in position in order to prevent it from sliding out of the chassis
during transportation.
Ê If applicable, fold down the handle on the power supply unit (3).
6.4.4

Concluding steps

"Connecting the server to the power source" on page 57
Ê
Ê In non-redundant PSU configurations, switch on the server as described in
section "Switching on the server" on page 58
"Performing a fan test after replacing a defective fan" on page 86
Ê
"Resuming BitLocker functionality" on page 80
Ê
98 Upgrade and Maintenance Manual
RX4770 M1