Upgrading Or Replacing A Processor; Concluding Steps - Fujitsu PRIMERGY RX4770 M1 Upgrade And Maintenance Manual

Processors

11.4.2 Upgrading or replacing a processor

I
This description applies to the following procedures:
– Installing another processor
– Transfering a processor after replacing the system board (see section
"Replacing the system board" on page
– In case of installing another processor remove the protective cover as
described in section
– Remove the desired processor as described in section
processor" on page
– Install the new processor as described in section
page 233.

11.4.3 Concluding steps

"Installing processor heat sinks" on page 252
Ê
"Installing the mid-brace" on page 239
Ê
"Installing memory boards" on page 223
Ê
"Installing expansion cards" on page 142
Ê
"Reassembling" on page 53
Ê
"Connecting the server to the power source" on page 57
Ê
I
If Global Error LED is flashing with error message CPU has been
changed on display after the system is powered on, please follow the
procedure below.
Ê Restart your server.
Ê As soon as the startup screen appears, press the [F2] function key to
enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the LED stops flashing.
250
"Installing a processor" on page
241.
Upgrade and Maintenance Manual
298)
233.
"Removing a
"Installing a processor" on
RX4770 M1