Table of Contents
Advertisement
LOWR
INSPECTION
156000-0
DRIVE SHAFT AND PROPELLER
SHAFT
1. Visually inspect the shafts, looking for
grooved wear on the surface in contact
with the bearings and oil-seals, and
looking for wear on the splines. Replace
if worn or damaged.
156300-0
DRIVE SHAFT SLEEVE
1. Visually inspect the sleeve for wear and
cracks. If any damage is found, replace
the sleeve.
156500-0
SHIFT-PLUNGER, SHIFT-SHAFT, AND
BOOT
1. Inspect the shift-plunger for signs of
wear or damage, dents in the contact
surface, replace if required.
2. Inspect the shift-rod boot for breakage
or damage, and replace the boot if dam-
age is found.
157000-0*
PROPELLER/TRIM TAB/ANODE
Refer to chapter 3 for periodic inspection
instructions.
6-9
E
Advertisement
Table of Contents
