Removing the drive shaft
1. Remove the drive shaft assembly and
pinion, and then pull out the forward
gear.
Drive shaft holder 3 1: 90890-06517
Disassembling the drive shaft
1. Install the pinion nut 1, tighten it finger
tight, and then remove the drive shaft
bearing 2 using a press.
CAUTION:
• Do not press the drive shaft threads a
directly.
• Do not reuse the bearing, always
replace it with a new one.
Bearing inner race attachment 3:
90890-06643
Disassembling the forward gear
1. Remove the taper roller bearing from the
forward gear using a press.
6D55F11
1
S68S6150
Drive shaft and lower case
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
Bearing separator 1: 90890-06534
Disassembling the lower case
1. Remove the taper roller bearing outer
race and shim(s).
NOTE:
Install the claws as shown.
Bearing puller assembly 1:
90890-06535
Stopper guide plate 2: 90890-06501
1
2
3
4
5
6
7
8
9
6-16